How to Sew Adhesive Strips onto your Plate Carrier and IceVents® Pontoons to install IceVents® Body Armor Ventilation Pontoons

How to Sew Adhesive Strips onto your Plate Carrier and IceVents® Pontoons to install IceVents® Body Armor Ventilation Pontoons

Sewing the adhesive Velcro loop strips included with IceVents® Classic Plate Carrier Ventilation Pontoons is super easy. We STRONGLY recommend sewing for strenuous applications like infantry live fires, o-courses, and maritime applications like MIO, OTB, and VBSS.  

First, place the adhesive loop strips toward the edge of the inside panel of your plate carrier so that when IceVents® are installed, the edge of the IceVents® are at the edge of the plate carrier to allow air to flow through the IceVents®. The lines in the picture below indicate the sewing lines:

Sewing instructions for installing loop fields for IceVents Body Armor Ventilation Pontoons

Here is an image showing where the stitch lines would be with the IceVents® installed. Stitch the adhesive loop strips to the plate carrier. Do not sew the adhesive loop strips to the IceVents®. The image below is for demonstration/reference purposes only.

how to sew loop strips onto your plate carrier to mount stand-off ventilation pontoons
Another example of where to place your plate carrier loop strips:
IceVents Classic Plate Carrier Ventilation Pontoons

 


Leave a comment

Please note, comments must be approved before they are published

This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.